Questions
Rook Stone Restoration answers common questions about cleaning, sealing and repairing stone. Stone care, answered.
How stone is cleaned, repaired and protected — the questions that come up most often before a project starts.
How do you clean marble without damaging it?
Marble is cleaned with a pH-balanced detergent chosen for the material and with low-pressure hot water, never with abrasives. A test patch is run before any full cleaning so the result can be checked first. Where the surface has dulled, it is honed and re-polished in place to restore an even sheen without losing the veining.
Can chipped or spalled stone be repaired instead of replaced?
Usually, yes. Chips, spalls and damaged edges are repaired and matched to the stone around them, and units are replaced only where they can no longer do their job. Repairs use matched stone and compatible mortars so the original character of the building is kept rather than covered over.
What is poulticing?
A poultice is a paste applied to the stone that draws embedded soiling and staining out of the surface as it dries. Masonry poultices are used for deep-set staining that ordinary washing will not lift, which is common on limestone, sandstone and travertine.
What is a Dutchman repair?
A Dutchman is a piece of matching stone set into a damaged area, such as a spalled corner or a missing section of moulding, so the repair reads as part of the original unit rather than a filled hole. It is one of the options used alongside pinning and grouting when stone has cracked or displaced.
How often should stone be sealed?
It depends on the stone and how exposed it is. Moisture is tested before any sealer is applied, and a reapplication schedule is set from that exposure rather than from a single interval applied to every building.
Should stone be sealed with a penetrating or a film-forming sealer?
For most stone the recommendation is a breathable penetrating sealer. It reduces water absorption while leaving the stone able to breathe, which limits staining, efflorescence and freeze-thaw damage. A film-forming coating can hold moisture in the masonry instead of letting it dry, so it is only recommended where the material calls for it.
Can you match the color of my existing mortar and stone?
Yes. Mortar is matched in color, strength and composition, and replacement units and patch repairs are matched to the surrounding stone, including cast stone copings, moulded profiles and surrounds.
Where does Rook Stone Restoration work?
Rook Stone Restoration is based in Salt Lake City, Utah. Projects are located in Salt Lake City and along the Wasatch Front, and the studio has also worked in Denver and Aspen, Colorado; Los Angeles and San Diego, California; Raleigh, North Carolina; Baltimore, Maryland; and Orlando, Florida.
Next Step